Monnit MoWi (Wi-Fi) Sensor Programming Utility

The following download will install the Monnit Wi-Fi Sensor programming utility on your computer. This application is needed in order to program your Monnit Wi-Fi (MoWi) sensors with Wi-Fi network security information if using WEP, WPA or WPA2 standards.

Monnit Wi-Fi (MoWi) Sensor Programming Utility

ALTA - Leading Enterprise Grade "Internet of Things" Solutions

ALTA sensors offer 3 to 4 times the range of standard sensor platforms, extending non-line-of-sight reach to an exceptional 1,200+ feet through walls (12-14 walls typical). Using Frequency-hopping Spread Spectrum (FHSS) also allows ALTA sensors to have better interference immunity from other wireless devices.Superior power management provides ALTA sensors with almost twice the battery life of Monnit’s standard wireless sensors.

• Coin cell sensors typically last 3+ years.
• AA and Industrial sensors typically last up to 12+ years.

ALTA products employ Monnit's new Encrypt-RF® Security (256-bit Diffie Hellman key exchange and AES-128 CBC encryption for all sensor data messages), so security is maintained at all communication points from sensor to gateway, gateway to software, then back again.

Integrated on-board data storage allows ALTA sensors to store data messages if communication to a wireless gateway is disrupted (power outage, Internet outage, or out of range). Messages that can’t be delivered will be time-stamped and stored in memory (up to the last 512 messages) until communication with the gateway is restored, at which point the messages will all be transmitted.Over-the-air updates allow ALTA products to be updated remotely if new fixes or features become available.The standard version of this sensor is powered by two replaceable 1.5 V AA sized batteries (included with purchase). This sensor is also available with a line power option. The line powered version of this sensor has a barrel power connector allowing it to be powered by a standard 3.0 - 3.8 V power supply (Included with Line Power option upgrade). The line powered version also uses two standard 1.5 V AA batteries as backup for uninterrupted operation in the event of line power outage.Power options must be selected at time of purchase, as the internal hardware of the sensor must be changed to support the selected power requirements.

Getting started with MoWi (Wi-Fi) Sensors

Step 1

Download and install the MoWi set up application. This simple program will get your sensors setup and online

Download

Step 2

Download and install the USB cable driver, for programming Wi-Fi sensors

Download

Step 3

Run the MoWi set up application to add Wi-Fi sensors to your Wi-Fi network and iMonnit account

Congratulations

You can now monitor your wireless sensirs from anywhere, using iMonnit, the online sensor monitoring system!

For more information on the MOWI Programming procedure visit http://www.mowisensors.com/